美国罗克韦尔光电编码器

美国罗克韦尔光电编码器，AB光电编码器技术规格
8. Make the electrical connections according to the table
under “Electrical Connections.”
IMPORTANT: Wiring must be in accordance with the
National Electric Code and applicable local codes and
ordinances.
9. Apply the specified voltage (see Table “e” under
“Selection” on page 1 of this publication).
2.将编码器滑到配合轴上，直到系带座或防转销固定在机器表面上。
编码器应在轴上自由滑动; 如果没有，不。
检查轴是否有干扰，如沟槽，毛刺，锈蚀或尺寸。
如果安装孔或防旋转销止动件已经存在，则继续执行步骤6。
3.标记安装孔和/或防转销停止位置。
1. Loosen the screw on the clamping ring with a 3/32 inch
hexagon socket wrench.

美国罗克韦尔光电编码器，AB光电编码器技术规格
2. Slide the encoder onto the mating shaft until the tether
mount or anti-rotation pin rests on the machine surface.
The encoder should slide freely on the shaft; if not, do not
force. Check the shaft for interferences such as gouges,
burrs, rust or size.
If a mounting hole or anti-rotation pin stop already exists,
proceed to step 6.
3. Mark the mounting hole and/or anti-rotation pin stop
location.
4. Slide the encoder off. Drill and tap the marked hole to
accept the 0.375 inch x 16 (tether option B or C) or 0.5
inch x 13 (tether option A) bolt.
4.关闭编码器。 钻取并点击标记的孔以
接受0.375英寸x 16（系绳选项B或C）或0.5英寸x 13（系绳选项A）螺栓。
高频响应
盲轴和全通轴前端耦合型
不需要柔性耦合器
IMPORTANT: Do not stress the tether mount while
tightening the bolt.
7. Tighten the clamping ring to 8 inch-lbs.

，AB光电编码器技术规格